Comtek AT-216 Betreibershandbuch PDF herunterladen (Seite 7)

Page 6

Belt clip installation

M-216 SNAP-ON BELT CLIP (Included)

Belt clip removal

c. Turn on the transmitter with program from the audio source being fed to

the transmitter. Observe the audio “voice” level modulation indicator. A full

bright LED indicates full audio compression at 100% modulation. For best

performance, the audio input gain should be adjusted for some low level

LED luminescence during normal audio levels with occasional full bright

peaks indicating 100% modulation.

d. When using the auxiliary audio input with the microphone plugged into

the transmitter, priority should be given to the microphone gain adjustment.

The mixing balance between the auxiliary audio and the microphone should

be made with the volume control of the auxiliary audio source.

Note: The optional microphone mute switch only affects the

microphone. It does not affect the auxiliary audio input.

M-216 OPERATING INSTRUCTIONS

STEP 1:

Hook belt clip

retaining lip over

front case ridge.

STEP 2:

Rotate belt clip down onto case. Apply

pressure on both sides of clip, snapping

clip retainers into slots.

Clip retainer

Retainer slot Belt clip removal indent

Flex out and pull down with your

thumb or a large coin (quarter) to

unsnap belt clip from case.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

Comtek AT-216 Betreibershandbuch Seite 7